8 bit
-
Control plate for 3D printers with the possibility of using digitally controlled engines (TMC2130-SPI and TMC2208 -serial) without the need for external "wire".
Availability: Sold out
$32.91
-
The motherboard is the brain of the 3D printer, which is based on the AVR processor ATmega2560.
Availability: Sold out
$40.23
-
Control plate on 6 step engines (XYZ and 3x extruder). Compatible with all drivers from our offer. The 12-24 V power supply is supported by 2004 (Reprap Discount Controller) and 12864 (Full Graphich Controller). Compatible board for ramps 1.4. Any firmware can be used.
Availability: Permanently out of stock
$43.89
-
RepRap Arduino Mega Pololu Shield 1.6 The latest version of the popular album RAMPS. Mosfets were replaced by more powerful and are under a large cooler. Also, the terminal block has been upgraded and now you do not have to change anything.
Availability: Permanently out of stock
$10.94
-
RepRap Arduino Mega Pololu Shield 1.5 New version of your favorite board. Transistors controlling all heating are in direct contact with a printed circuit board and thus more efficient cooling. The more powerful MOSFETs were also used and therefore version 1.5 will work even more reliably.
Availability: Permanently out of stock
$8.02
-
Motherboard for Anet version 1.5 printers. The board is used in all printers from Anet.
Availability: Sold out
from $7.28
-
$23.76
-
Reprap Arduino Mega Pololu Shield 1.6 Plus The latest version of the popular RamPs album. Mosfets were replaced by more powerful ones and are under a large cooler. Also, the terminal block has been upgraded and now you do not have to change anything. In addition, double connectors.
Availability: Sold out
$12.77
-
$10.94