HD PLALAMENT WORITE RED 1.75mm Fiberlogs 850g

HD PLALAMENT WORITE RED 1.75mm Fiberlogs 850g

HDPLA fiberlogs is a special material that can be used in many ways as a replacement for ABS, but in much easier printing. The Fiberlog HDPLA material is as well as higher temperatures, but it is printed as a classic PLA. Read more

1-7 days

28,17 €

Producer: Fiberlogy

Other currencies

Approximation of price, the exact amount is at the end of the shopping cart


1. Print your project.

• print temperature: 200 ° - 220 ° C

• pad temperature: 50 ° - 70 ° C

(pad heating is not necessary if you use pads, tapes or adhesives that increase adhesion)

3. Printing should be placed in the middle of the chamber (oven), evenly distant from the heating elements inside.

4. Gradually heat it to a temperature of about 80 ° C.

It is recommended to monitor the temperature using a suitable digital thermometer inside the oven. The printout needs to be guarded during the process. In the case of massive prints, you can gradually increase the temperature to 120 ° C or extend the annealing time.

6. After the annealing, remove the print with the pad on which it was placed in the chamber and do not touch it until it cooled (at room temperature).

7. Remove support and raft.

8. Now you can take a finished product that has gained mechanical strength similar to ABS and temperature resistance up to 140 ° C. The model at such a high temperature can then soften but does not break and hold shape.



2. Check that the oven temperature corresponds to the actual temperature.

3. During the annealing process, there is a lower product shrinkage. Unfortunately, he cannot be prevented. According to our experience it is about 1 mm per 10 cm. It is a kind of reconstruction of the internal structure of the material (a change in crystalline structure, such as it happens, for example, in steel during curing). The shrinkage rate depends on the filler used. The greater the fill, the smaller the shrinkage should be.

Subsequent grinding or other modification of the model you can achieve accuracy, or count this shrinkage and print the model larger.

More from category

Additional information

Category: PLA
Barva: červená
Váha materiálu: 0,85 kg
Průměr: 1,75 mm
Přesnost struny: ± 0,02 mm
Teplota podložky: 0-70°C
Teplota trysky: 200-220°C
HD PLALAMENT WORITE RED 1.75mm Fiberlogs 850g
HD PLALAMENT WORITE RED 1.75mm Fiberlogs 850g

28,17 €

New product question




Forgotten password

Privacy preferences
We use cookies to enhance your visit of this website, analyze its performance and collect data about its usage. We may use third-party tools and services to do so and collected data may get transmitted to partners in the EU, USA or other countries. By clicking on 'Accept all cookies' you declare your consent with this processing. You may find detailed information or adjust your preferences below.

Privacy declaration

Show details
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.


Forgotten password

Are you a business customer or a private customer?

Business customer Private customer
Product has been added to the cart
Continue shopping Order